triggering selected sample part (in Slate)

Hi,
is it possible to trigger only the portion of the sample that you have selected (when you make a loop inside the Sample Editor) ? Because using the Offset knob is not very handy, and not very accurate on long sample. But when I make a selection in the Sample editor, use the “Editor loop” and enable the loop mode, when I close the editor, the pad still triggers the all sample and not the part I selected.

Comments

  • edited January 2019

    no, currently there is no other way set "sample start" in Slate than that knob... Some more advanced way to set sample start is on todo list, but no ETA for now...

  • @dendy said:
    no, currently there is no other way set "sample start" in Slate than that knob... Some more advanced way to set sample start is on todo list, but no ETA for now...

    It would be easier if sample start was on the same page as the envelope parameters. I was trying this using 1 sample and it wasn’t too bad except for having to switch pages. I’m sure there’s still a better way.

Sign In or Register to comment.